Boiling Range:  High-   N/A              Low-   N/A

Vapor Pressure:  See Section II

Vapor Density:  N/A

Evaporation Rate:  N/A

Weight per Gallon:  8.40 lbs

% Volatile by Weight:  98.00

Appearance:  N/A

pH:  N/A

SECTION IV  - FIRE AND EXPLOSION HAZARD DATA

Flammability Classification:   Class 3B

Actual Flashpoint TCC:   999.0

Lower Flammability Limit:  N/A

NO HAZARD WARNING MESSAGES FOR THIS PRODUCT


SECTION V  - HEALTH HAZARD DATA

 NO HAZARD WARNING MESSAGES FOR THIS PRODUCT

SECTION VI  - REACTIVITY DATA

 NO HAZARD WARNING MESSAGES FOR THIS PRODUCT

 SECTION VII  - SPILL OR LEAK PROCEDURES

 NO HAZARD WARNING MESSAGES FOR THIS PRODUCT
 

SECTION VIII  - SAFE HANDLING AND USE INFORMATION

 NO HAZARD WARNING MESSAGES FOR THIS PRODUCT

 PROTECTIVE EYEWEAR

Avoid contact with eyes.  Wear goggles if there is a likelihood of contact with eyes.
Eyewash stations and safety showers should be readily available in handling areas. Use
safety eyewear with perforated side shields.

RESPIRATORY PROTECTION

In outdoor or open areas use (NIOSH/MSHA approved) mechanical filter respirator to remove 
solid airborne particles of overspray during spray application.  In restricted ventilation areas use 
(NIOSH/MSHA approved) chemical-mechanical filters designed to remove a combination of 
particulate and gas and vapor.  In confined areas use (NIOSH/MSHSA approved) air line type 
respirators or hoods.  Respiratory protection may also be necessary in any later manufacturing 
operations in which the product may become airborne in the form of vapor or dust.

VENTILATION

Use ventilation as required to control vapor concentrations.  Avoid prolonged or repeated 
breathing of vapors.  If exposure exceeds TLV, use a NIOSH-approved respirator to 
prevent overexposure.

Provide general dilution or local exhaust ventilation in volume and pattern to keep TLV of
the most hazardous ingredient in Section II below acceptable limit, LEL in Section IV below
stated limit, and to remove decomposition products during welding or flame cutting on surfaces
coated with this product.

PROTECTIVE GLOVES

Required for prolonged or repeated contact.  Wear resistant gloves such as natural rubber,
neoprene, buna N or nitrile.  An apron should be worn to avoid skin contact.

SECTION IX  - SPECIAL PRECAUTIONS

 NO HAZARD WARNING MESSAGES FOR THIS PRODUCT

 SECTION X  -  313 TOXIC CHEMICALS 

NO HAZARD WARNING MESSAGES FOR THIS PRODUCT